Ecobee3 Thermostat Wiring Diagram Practical Ecobee Wiring Diagram Book Of Ecobee3 Wiring Diagram Fresh Elegant Ecobee3 Wiring Diagram Diagram Pictures
Related photos in this diagram:
Other recommended diagram ideas:
Fantastic Ecobee3 Thermostat Wiring Diagram Photos - In case your vintage thermostat didn’t have a “c” twine related, but you have an unused cord inside the wall that you can use as a “c” wire, label the whole thing and bypass to step four-and-a-1/2. While you’ve exposed your thermostat’s wiring, in case your unique installer did things right, the colour of the wires will match the letters at the wiring terminals. If finished preferably, a four-cord install would look something like this:.
Don’t fear if your twine colours don’t in shape exactly, or if there are perhaps extra wires than you were watching for. Different components (consisting of fan timers, or wires that run to a condensate pump. And so forth.) Might also be wired here (which is the case in all the above photos).?cognizance on locating the 4 wires which are presently running for your thermostat vicinity. They’ll nearly certainly be connected to the r, y, g, and w terminals at the control board. They’ll sooner or later organization together and head off towards your thermostat area. When you’re accomplished, close up your hvac unit and head again in your thermostat vicinity. You might also need to strip that end of the spare twine, too. Now which you have five wires connected on your hvac device, you’re ready to move to step 5.
After your far off sensor is set up, i suggest permitting each the “clever home / away” and “observe me” functions of the ecobee3, as those will permit your smart thermostat to be as “smart” as it could.?you can get admission to these settings from the ecobee3’s “sensors” menu. In case you didn’t need the pek, then absolutely join all of your labelled wires (which includes the “c” cord) to the matching terminals on the ecobee3 lower back plate.?your “r” wire can connect with both the rc or the rh terminal, because the ecobee3 will routinely “bridge” these terminals (except you used the pek, in which case you ought to use the rc terminal).